Air-drying and Draining Machine for Fruits and Vegetables
This machine is mainly suitable for drying fruits, vegetables, fungi and other products after cleaning. It can effectively remove water droplets on the surface of the product, suitable for assembly line operation, improve the automation level of the enterprise, blow dry at room temperature, and effectively protect the color and quality of the material itself.
The transmission of this machine adopts a speed regulating deceleration motor, which makes the air drying effect of the product adjustable and the mesh belt runs smoothly. Except for standard components such as fans and motors, all parts of this machine are made of 304 stainless steel.
Local features:
Each air outlet on the air dryer belt is equipped with 2 medium pressure centrifugal fans for drying, totaling 18 fans. Each air outlet under the mesh belt is equipped with 2 medium pressure centrifugal fans for drying, totaling 10 fans. Air volume: 2500-3000m3/h, air pressure: 600-700Pa, speed: 1450r/min, power: 0.75kW/unit, noise ≤ 70dB (A) To ensure hygiene requirements, except for the motor, fan duct, and volute, the air outlet is made of stainless steel, and an air inlet mesh cover is added to the air inlet.
Wind dryer drying section: length 6000mm, effective width 800mm, total power: 21.75kw
The machine adopts simultaneous blowing up and down, allowing both sides of the material to be fully air dried.
The rack part adopts 50 × 50 × 2 stainless steel square tubes, and the centrifugal fan bracket adopts δ=2.0mm thick stainless steel plate folding or L50 × 50 × 4mm stainless steel angle iron.
Note: ① Adopt independent control of the operating speed of the mesh belt.
② The reducers are all made of aluminum alloy shells.
③ The bearing seat is made of plastic steel shell above water and stainless steel below water.
④ All chain wheels on the production line are made of stainless steel.
Leave a reply